3DUpFitters CR-10S Pro/CRX R1 Enclosure Kit Manuel d'instruction - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} 3DUpFitters CR-10S Pro/CRX R1 Enclosure Kit. 3DUpFitters CR-10S Pro/CRX R1 Enclosure Kit 20 pages.

Imprimer la page

4. Assemble Back

The back of the enclosure when viewed from the back is

shown to the right. The four corner connectors are mirror

images of the front. The large hole is either for an air ﬁlter

(purchased separately) or can be covered up 3D printing a

cover using M4 10mm screws. (There's a link to the cover

on the product page.)

On the top and on each side are "mid panel corner

connectors", which are basically simple L-shapes.

If assembling the Charcoal Air Filter, conﬁrm the

direction of the fan's air ﬁlter by plugging it into a USB

power supply before attaching to the ﬁlter and back of

the enclosure using M4 cap head 30mm or 40mm

screws depending on the depth of the particular fan.

The air ﬁlter should look like this after being attached.

Note that its easier to insert the screws from the

inside, and put the nuts next to the ﬁlter housing.