3DUpFitters Ender 3 S1 Enclosure Kit Manuel d'installation - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} 3DUpFitters Ender 3 S1 Enclosure Kit. 3DUpFitters Ender 3 S1 Enclosure Kit 17 pages.

Imprimer la page

Attach the right panel as shown above at each of the four corners. You can now

attach the latch mount on the front using 2 M4 12mm cap head screws.

The new Ender 3 S1 has a diﬀerent display that

inserts into a mounting platform that also

attaches via the two corner connector screws on

the right panel. Rather than use the 12mm M4

screws as before, you'll use the longer 16mm M4

screws to attach both the corner connector and

the display mount.

The kit comes with a cable to attach the display on

the outside of the enclosure. The cable goes through

the enclosure in the slit as shown to the right.

5. Top Panel

Before attaching the top, now is

a good time to insert the support

beam. It is a tad wider than the

enclosure so that it doesn't fall

out when moving the enclosure.