Alto-Shaam 700-RW Manuel d'installation, d'utilisation et d'entretien - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel d'installation, d'utilisation et d'entretien pour {nom_de_la_catégorie} Alto-Shaam 700-RW. Alto-Shaam 700-RW 19 pages. Hot food holding, round wells, electric with halo heat technology
Imprimer la page
E L E C T R I C A L
CAUTION
Power source must match voltage identified
on appliance rating tag. The rating tag
provides essential technical information
required for any appliance installation,
maintenance or repairs. Do not remove,
damage or modify the rating tag.
W A R N I N G
To prevent SERIOUS INJURY, DEATH
or PROPERTY DAMAGE:
All electrical connections must be
made by a qualified and trained
service technician in accordance with
applicable electrical codes.
1. An identification tag is permanently mounted on
the appliance.
2. This appliance is equipped with a three-prong
grounding plug. For your protection against
shock hazard this appliance should be plugged
directly into a properly grounded three-prong
receptacle. Do not cut or remove the grounding
prong from this plug. Plug the unit into a
properly grounded receptacle ONLY, positioning
the unit so that the plug is easily accessible in
case of an emergency. Arcing will occur when
connecting or disconnecting the unit unless all
controls are in the "OFF" position.
3. Proper receptacle or outlet configuration or
permanent wiring for this unit must be installed
by a licensed electrician in accordance with
applicable local electrical codes.
NOTICE: Where local codes and CE regulatory
requirements apply, appliances must be
connected to an electrical circuit that is
protected by an external GFCI outlet.
NOTICE: Round Well must be installed with
15 Amp maximum overcurrent
protection or equivalent.
I N S T A L L A T I O N
700-RW
ELECTRICAL
1100-RW
ELECTRICAL
Other plugs are available. Contact factory for more information.
MN-35890 (Rev. 3) 04/16 • Round Wells • 8
W A R N I N G
To prevent SERIOUS INJURY,
DEATH, or PROPERTY DAMAGE:
All electrical connections must be
made by a qualified and trained
service technician in accordance
with applicable electrical codes.
This appliance MUST be adequately
grounded in accordance with local
electrical codes or, in the absence
of local codes, with the current
edition of the National Electrical
Code ANSI/NFPA No. 70. In Canada,
all electrical connections are to be
made in accordance with CSA C22.1,
Canadian Electrical Code Part 1 or
local codes.
WARNING
To prevent serious injury, death, or property
damage, always disconnect appliance from
power source before cleaning or servicing.
/
VOLTAGE
PHASE
CYCLE
HZ
120
1
50/60
208-240
1
50/60
1.6-1.9 .34-.45
230
1
50/60
7/7
CEE
/
VOLTAGE
PHASE
CYCLE
HZ
120
1
50/60
208-240
1
50/60
1.8-2.1 .38-.5
230
1
50/60
7/7
CEE
kW
AMPS
CORD
3.8
.45
NEMA
15A- 125V
NEMA
15A - 250V
1.8
.41
PLUGS RATED
2-16
CH
P
kW
AMPS
CORD
4.2
.5
NEMA
15A- 125V
NEMA
15A - 250V
2.0
.46
PLUGS RATED
2-16
CH
P
&
PLUG
5-15
P
PLUG
6-15
P
PLUG
250V
1363
BS
&
PLUG
5-15
P
PLUG
6-15
P
PLUG
250V
1363
BS