3DUpFitters Ender 3 V2/CR-6 Enclosure Kit Manuel d'installation - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit. 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit 15 pages.
Également pour 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit : Manuel d'installation (16 pages)

Imprimer la page

7. Tighten Gaps

Once the enclosure is completely put together, it is time to make sure that each of the

panels is held tightly to each adjoining panel. The connectors are designed with a

small amount of play that allows you to make small adjustments for the perfect ﬁt.

1. Loosen screws on the panel to move.

2. Push that panel into place. You may need a friend to hold it tightly in the right spot.

3. Re-tighten the screws to hold the panel. Only tighten enough to hold the pieces

snuggly. DO NOT OVER-TIGHTEN! These parts are sturdy, but they're still all made

out of plastic.

Repeat the product, going around the enclosure looking to make sure all of the panels

are ﬂush to each other.

8. Assemble Spool Holder

Instructions to assemble the spool holder are

available online in the product description, but it's

not too hard to just wing it.

The location that will give the least resistance is

placing the spool holder directly to the left of the

printer. Many people who are low on space,

however, place the spool holder on top, which

shouldn't make too much of a diﬀerent in print

quality.

Of course, if you don't like this spool holder you

are free to use whatever type of freestanding

spool holder you wish; there are hundreds of

designs available on Thingiverse.

The ﬁlament feeds into the extruder through

the gaps in the side doors.