ClearCube A1410 Manuel de démarrage rapide - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} ClearCube A1410. ClearCube A1410 2 pages. I/port
Également pour ClearCube A1410 : Manuel de démarrage rapide (2 pages), Manuel de démarrage rapide (2 pages), Démarrage rapide (2 pages), Manuel de démarrage rapide (2 pages)
Imprimer la page
7.
Align the V5120 card and the riser card, as shown in the
following figure. Gently insert the V5120 gold fingers into the
riser card's slot. Ensure that the cards are fully seated.
8.
Insert the cards in the motherboard expansion slot.
a.
Lower the connected cards into the blade, and gently
place the edge of the V5120 card between the upper and
lower rails of the support bracket.
b. Align the riser card's gold connectors with the 16x PCI
Express® expansion slot on the mother board. Press
down firmly to seat the riser card.
9.
Secure the mounting bracket to the top edge of the blade using
the two SEMS screws included in the kit.
10. Connect the Ethernet cable and the four–pin signal cable to
the matching connectors on the edge of the V5120 card.
–
Connect the other end of the Ethernet cable to the single
Ethernet connector on the rear of the blade (do not
connect the cable to the dual Ethernet connector
adjacent to the power supply).
–
Connect the other end of the signal cable to the four–pin
connector on the I/O motherboard on the rear of the blade
(the letters RGH are printed above the four–pin connector).
ClearCube Technology
Place edge of card
between rails
8834 Capital of Texas Hwy N
Austin, Texas 78759
Ensure that you thread the cables under the blade frame's
center channel after connecting the cables.
Connect
4–Pin Cable
Here
11. Replace the top cover and the I/O cover and screw the covers
into place (see step 2 and step 3 for screw hole locations).
12. Remove the backing from the V5120 configuration label included
in the kit and place it on the outside of the A1410 blade frame.
Note: If a video card configuration label is already on the blade
in the indicated location (for example, if you are replacing
or upgrading an existing V5120 or V5140 card), ensure
that you remove the old label before applying the label in
the upgrade kit. If you cannot remove the old label, place
the new label on top of the existing label.
Place configuration label on outside of
blade frame in this location
After installing the V5120 card, replace the blade in a cage and
reconnect power.
Additional Features and Information
See A–Series Data Center Products Reference Guide on
support.clearcube.com for more information about blade usage
and configuration, including topics such as:
•
Mass storage lockout
•
Network cabling and site preparation
•
Chassis and blade installation
•
Firmware compatibility
Email:
Web site:
support.clearcube.com
Toll-free:
(866) 652-3400
Phone:
(512) 652-3400
voice 512 652 3500 www.clearcube.com
Connect Ethernet
Center
Cable Here
Channel
G0200107 Rev C