esera automation 11216 Manuel de l'utilisateur - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} esera automation 11216. esera automation 11216 7 pages. 8-fold digital input for 1-wire bus
Également pour esera automation 11216 : Manuel de l'utilisateur (9 pages)

Imprimer la page
3
Auto-E-Connect® Support
The ESERA Auto-E-Connect® 1-Wire Plug and Play system will be used for the
1-Wire Bus supported. This enables fully automatic configurations of 1-Wire sensors
and actuators on the 1-Wire bus. It is optimized for industrial applications and
enables significant added value beyond the sensor and chip data.
The Auto-E-Connect function automatically recognizes ESERA chips, sensors and actuators, starts suitable
libraries and outputs fully formatted data.
The Auto-E-Connect functionality will be available from mid-2020 via 1-Wire Controllers, 1-Wire Gateways and
1-Wire ECO from ESERA available.
Further information on ESERA Auto-E-Connect can be found on the ESERA website, ESERA Config-Tool 3,
or in the download area for this article in the ESERA Webshop.
4
Technical data
Inputs
Number and type:
Input voltage:
Filter:
Insulation:
LED displays:
Interface
1-Wire Component:
Interface:
Supply power:
Power consumption
Internal fuses:
Insulation voltage:
Connection:
Note:
5
Ambient conditions
Protection system:
Protection class:
Temperature (operation): 0 °C up to +50 °C
Air humidity:
Dimensions:
All rights reserved. Reproduction as well as electronic duplication of this user guide, complete or in part, requires the written consent of
ESERA GmbH. Errors and technical modification subject to change. ESERA GmbH, ESERA-Automation 2020
www.esera.de
8 inputs for direct power voltage signals 10 - 30VDC
maximally 30 VDC, maximum 8mA, low level: <5V, high level 10-30V
Software filter for switch bounces (30ms delay)
Inputs are electrically insulated against 1-Wire Bus (optocouplers)
10 LEDs (Power LED, Status LED, 8 x Input)
Input LED is lit at Status High of the 1-Wire DS2408 Interface
DS2408 (8-Fold I/O)
1-Wire Bus (12V, data and load)
12V= (+/-10%)
12V: maximum 40mA, all inputs active
no exchangeable fuses available
minimum 500VAC provide 1-Wire Bus
Screw terminals (up to 2,5qmm wire cross section)
Only a 12 V power supply is required for the operation of this module. We recommend
the use of one of our 1-Wire Hub Modules.
Input voltages higher than 30V can cause damages to the module
IP20
III
10 – 92 % (non-condensing)
32 x 90 x 70mm (BxHxD)
11216 V4.0 R1.0 Manual
Page 2 of 7