BaltLED BACKLIT BAR Manuel d'installation

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} BaltLED BACKLIT BAR. BaltLED BACKLIT BAR 2 pages.

Imprimer la page
BACKLIT BAR
READ THE INSTRUCTIONS CAREFULLY BEFORE MOUNTING
IP 20
Tools reguired.
Wires, wire strippers, drill, screwdriver,
screws, surface cleaner, wire connectors and end caps.
3.
For firm fixing, use screws to secure LED bars within
the lightbox. Depending on the mounting surface, set
proper torque to not damage bar mounting lungs.
6.
Choose a 24 VDC power supply*. Before connecting
wires to the power supply:
connector with additional male connector.
the female connector off, then – connect extension
cable using connectors (if needed cable extension).
*Take in consideration the insolation class for the power supply and connectors outside the lightbox, depending on the place it will be stored.
CONNECTION SCHEME
!
10 pcs
- max number of LED bars in one chain when the power supplied from single end.
! String end voltage can't be less than 23V, do not exceed specified bar string length
POWER SUPPLY LOAD RECOMMENDATIONS
POWER SUPPLY
BPSP-40-24V.1
BPSP-60-24V.1
BPSP-100-24V.1
BPSP-150-24V.1
© 2023, All rights reserved BaltLED, UAB. Specifications are subject to change without notice.
www.baltled.com
1 /
2
August 7, 2023
INSTALLATION GUIDE
1.
Clean the inside of the sign with surface cleaner
(e.g. ethanol) to make sure it is free of dirt.
4.
Connect the bars by connecting female connector
with male connector.
7.
Connect the white wire with red stripe (+) of the LED
bars to the positive wire (+) of the power supply. Connect
Option 1.
Connect female
the white wire (-) to the negative wire (-) of power supply.
Option 2.
Cut
QUANTITY
2 m*
2
bars
mm
AWG
3
1.3
16
4
1.5
15
8
2
14
13
3.3
13
!
20 pcs
- max number of LED bars in one chain when the power supplied from both ends (additional wiring is needed)
! String end voltage can't be less than 23V, do not exceed specified bar string length
5 m*
10 m*
2
2
mm
AWG
mm
2.5
13
6
4
11
10
6
10
10
10
7
16
2.
Remove protective layer from the backside of the
bar and stick the bar into place.
5.
Cap all unused wires. First - cut the connector off,
then – cap the wires).
8.
Finish by connecting AC power line to the input
wires of the power supply.
AWG
10
7
* Distance between power supply and bars.
7
! Power loss less than 5%.
! Recommendations for optimal use of power supply.
5