ESI EPPA2-KIT Manuel d'instructions - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour {nom_de_la_catégorie} ESI EPPA2-KIT. ESI EPPA2-KIT 12 pages. Dual monitor arm conversion

Imprimer la page

MONITOR INSTALLATION

Attach Monitors to VESA Mounts

There are two sets of four holes on each VESA mount. One set has holes 3.9" (100mm) apart, the other set

has holes 3" (75mm) apart. Use the set that matches the holes on the monitor.

• Place the monitor face down on a flat surface.

• Attach D5 washers and M4x12 or M5x12 screws (depending on monitor hole size) to the top two holes on

the monitor. Leave

— If using the inner holes on the VESA mount, do not use the washers. The screw heads without washers

will fit through the large part of the keyhole openings.

• Hook the monitor onto the VESA mount, as shown.

• Install and tighten screws and washers into the bottom two holes. Then tighten the top two screws.

• Repeat for the second monitor.

M4x12 or

M5x12

Capture Monitor Cables and Power Cords

Cable covers on the underside of each monitor arm are used to neatly

organize the monitor cable and power cord.

Remove Cable Covers

• Slide the lower cable cover up toward the

monitor to remove it. Do not attempt to

snap it off.

• Pull apart slightly the upper and lower

ends of the other cable cover to

remove it from mounting holes

on the monitor arm.

" to

" (3mm to 5mm) of exposed threads between the washer and monitor.

EPPA2-KIT