ESI KATA-GM-SLV Manuel d'instructions d'installation - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} ESI KATA-GM-SLV. ESI KATA-GM-SLV 12 pages. Monitor arm

Imprimer la page

Kata

Step #8: make any necessary adjustments

There are five possible swivel and tilt tension adjustments:

1. Monitor tilt adjustment

— To change monitor tilt angle, use the 4mm end of the dual Allen key to loosen the screws on the sides of the VESA mount. Tighten the screws to hold the angle.

2. Monitor swivel adjustment

— Use the 4mm end of the dual Allen key to adjust the underside screw behind the VESA mount for the desired ease of monitor rotation.

3. Motion arm weight adjustment

— Use the 4mm end of the dual Allen key to adjust the screw at the top of the fixed arm for the appropriate monitor weight.

4. Motion arm swivel adjustment

— Use the 4mm end of the dual Allen key to adjust the screw in the underside of the fixed arm for the desired ease of motion arm rotation.

5. Fixed arm swivel adjustment

— Use the 2mm end of the dual Allen key to adjust the bottom M4x6 set screw in the recessed area of the fixed arm for the desired ease of rotation.

(If you did not install the M4x9 set screw in the top hole on the previous step, then this step (#5) is required. This will secure the monitor arm onto the base mount)

behind VESA plate

monitor

not shown

M4x6

Page 8

Assembly