ESI ALL-FLEX FLEX3-WHT-V1 Manuel d'assemblage et d'utilisation - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel d'assemblage et d'utilisation pour {nom_de_la_catégorie} ESI ALL-FLEX FLEX3-WHT-V1. ESI ALL-FLEX FLEX3-WHT-V1 12 pages. 3 leg electric table base
Imprimer la page
ALL-FLEX
3 LEG ELECTRIC TABLE BASE
™
STEP 8
Attach a foot to each of the legs.
• Use four M10x45 screws per foot.
• Tighten the screws with an 5mm Allen key.
STEP 9
Adjust the position of the frame before attaching it to the work surface.
• Align the rear of the feet with the rear of the table.
• Center the center leg on the 90° or 120° angle.
• Check that the top supports on each side are approximately 1" (25mm) from the ends of the table.
• The rear of the feet should align with the rear of the table. With that alignment, the center leg top
supports will be 6½" from the rear of the table.
• Check that each cross channel's center line is centered between the frame and top support, and that
the MAX lines do not extend beyond the frame and top support.
1"
6
6½"
Align Rear of Feet
with Rear of Table
90°
5mm Allen Key
6½"
1"
ASSEMBLY
M10x45
120°
1"