ESI FLEXRISE2 Manuel d'instruction - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} ESI FLEXRISE2. ESI FLEXRISE2 16 pages. 2 leg / 2 motor electric table base (36 inch to 72 inch)
Imprimer la pageISSUE
The Frame / Column is not running.
The Frame / Column operates
irregularly or is tilted.
The Frame / Column stops and can
only run downwards.
The Frame / Column will only run
downwards even though the frame is
not overloaded.
The Frame / Column always stops at
the same position, before reaching
maximum height.
Not all Columns run when you run
the frame downwards.
TROUBLE SHOOTING GUIDE
INSPECT
Is the power cable connected
to the main power supply with
correct voltage?
Make sure that all plugs are
mounted correctly in the
control box and to the
columns.
One or more columns/cables
are defective.
Look for visible damages on
cables, control box and
columns.
Visual observation.
Is the frame in highest
position?
The frame could be
overloaded.
Visual observation.
Has the system been
programmed to this specific
height?
The column that does not run
could be defective or the
cable connection for the
column is not ok.
SOLUTIONS
Connect plug to main power
supply to make sure the
voltage is ok.
If not then try to connect
another device (ex lamp) to
check.
Check all connections
Perform resetting and run a
bit upwards. If a column will
not run upwards after
resetting, it is defective.
Damaged parts must be
exchanged - contact supplier.
Perform Resetting.
When the frame has reached
the maximum height, it can
only run downwards.
Remove some of the load
and perform again.
Perform Resetting.
Perform Resetting.
Check all connections, then
Perform resetting. If a column
will not run upwards after
resetting, it is defective.
P3