ClearMirror BigSexy 16105-306024M Manuel d'instructions d'installation - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} ClearMirror BigSexy 16105-306024M. ClearMirror BigSexy 16105-306024M 7 pages. Showerlite led back-lit, fog-free shower mirrors
Imprimer la pageWARNING: This stage requires a qualified electrician and conformance with both the National
Electrical Code and local building codes. Turn off the power to the circuit connected to the light
fixture at the disconnect means. Failure to do so could result in death or serious injury.
Wiring the LED
The ShowerLite uses a custom power breakout board to receive power and connect LED(s).
Maximum distance from mirror to the LED driver is 40 ft. Driver also has a 6 ft. AC cord with plug.
If not already mounted, the power breakout board can be mounted on the mirror as needed (near the
LED or near the heater leads). It comes with double stick adhesive. The LED lead and power supply
lead connect to any open spot on the power breakout.
The LED power supply is plugged into a switched outlet. The outlet is either dedicated for the
ShowerLite or tied into another switched light in the bathroom.
1. Run power supply wire from the provided low-voltage plug-in power supply to the opening at the
mirror location. The 24V power supply wire is 40-feet long and runs through the wall.
2. Before mounting the mirror, connect the power and test LEDs and heater.
NOTICE: Use only supplied LED wiring between the mirror and the outlet. All wiring must be in
accordance with applicable installation code, NFPA 70-2011, National Electric Code.
The direct plug-in power supply must be accessible for service and replacement and must have
some air flow. Do not mount the power supply in a closed wall. Common locations include:
cabinets, closets, attics and adjoining rooms.
Figure 2. LED power supply and power breakout.