ClearMirror Studio Custom Manuel d'instructions d'installation - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} ClearMirror Studio Custom. ClearMirror Studio Custom 6 pages. Handcrafted, fog-free vanity mirrors
Imprimer la page
NOTICE: All wiring must be performed by a licensed electrician. Follow the National Electrical
Code or local codes as applicable.
WARNING: Failure to follow instructions could result in death or serious injury.
NOTICE: ClearMirror height is usually 2 inches higher than the tallest user's height.
NOTICE: ClearMirror heater must be smaller than the mirror. Leave at least a 1" space from
mirror edges to the heater edges.
General Guidelines
Install the Studio Series with heater to a junction box in accordance with all applicable safety,
national and local electrical codes. All wiring between the mirror heater and the bathroom light
junction boxes must be installed per local and national electrical codes using wire system
identified by the National Electrical Code. Consult a qualified electrician for all wiring.
• Do not install on mirrors located on uninsulated external walls.
• Only wire the pad to a 110/220 volt power supply.
• These installation procedures are for mirrors that are not permanently installed. Consult
local authorities for variations in installation.
• Use caution with all electrical appliances. Install according to these instructions.
Installation
Wire the ClearMirror heater to a junction box in accordance with all applicable safety, national
and local electrical codes. All wiring between the mirror heater and the bathroom light junction
boxes must be installed per local and national electrical codes using wire system identified by
the National Electrical Code. Consult a qualified electrician for all wiring.
• Choose the mirror defogger location.
• Install an electrical junction box.
• Wire mirror defogger to junction box to switched 110/220 power supply to ensure it is turned
off when not in use.
• Use two people for safety.
TOOLS NEEDED
Electrical tape, flashlight, 4-yellow or red wire connectors, non-sheathed wire cable,
remodeler's junction box, utility knife, wire strippers, screwdriver, pliers and keyhole saw.