ClearMirror Studio Series Manuel d'instructions d'installation - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} ClearMirror Studio Series. ClearMirror Studio Series 6 pages. Handcrafted, fog-free vanity mirrors
Imprimer la page
NOTICE: Polarity is not relevant - there are neither positive nor negative connections on the
ClearMirror heater pad, nor are there any ground wires.
NOTICE: Studio Series mirrors are heavy. Always use two people when moving and installing.
MOUNT Z-BRACKET TO WALL
1. Locate center on wall and mark
2. Place Z-bar bracket with tabs up and out a minimum of 6.5" from top edge of the mirror,
level and mark hole locations.
3. Locate and use studs, if possible. If no studs are found, use wall anchors (3 anchors are
provided - minimum weight of 75 lbs to be supported).
4. Mount Z-bar bracket on wall with screws (included).
5. Screw anchor in flush with wall.
Figure 2. Locating position of Z-bar bracket.
WIRE TO OVERHEAD LIGHT FIXTURE
• Disconnect overhead light fixture base from the wall to expose the junction box.
• Drop down a Romex (non-sheathed) cable to the ClearMirror junction box below.
CONNECT LEADS TO POWER SUPPLY
1. With assistance of another person, position the mirror to connect the heater leads to the
wire cable in the junction box.
2. Connect the mirror heater and power wires.
3. Wrap wire connectors and wire with electrical tape and push excess into junction box.
4. Replace light fixture onto base.
5. Turn on circuit breaker and switch for overhead light.
6. Test ClearMirror by placing hand on surface of mirror. It should heat in two minutes.
NOTICE: Ensure leads are not stuck between the mirror and the wall
Figure 3. Installing drywall anchors