Alto-Shaam SC-36/2S Manuel d'installation, d'utilisation et d'entretien - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel d'installation, d'utilisation et d'entretien pour {nom_de_la_catégorie} Alto-Shaam SC-36/2S. Alto-Shaam SC-36/2S 16 pages. Countertop merchandiser
Également pour Alto-Shaam SC-36/2S : Fiche technique (2 pages), Brochure (4 pages), Brochure & Specs (4 pages), Spécifications (2 pages)
Imprimer la page
U N PA C K I N G a n d S E T- U P
The Alto-Shaam appliance has been
thoroughly tested, checked for
calibration, and inspected to insure
only the highest quality unit is
provided. When you receive it,
check for any possible shipping
damage and report it at once to the
delivering carrier. See
Transportation Damage and Claims section
located in this manual.
Save all the information and instructions packed
inside with the unit. Complete and return the
warranty card to the factory as soon as possible to
assure prompt service in the event of a warranty
parts and labor claim.
Alto-Shaam heated shelf units are designed for the
purpose of maintaining hot food at a temperature
for safe consumption. The unit must be installed
on a level surface in a location that will permit the
equipment to function for its intended purpose and
allow adequate access for proper cleaning and
maintenance. Installation minimum clearance
recommendation: 3
"
and 1" (25mm) on each side.
NOTE: Any claims for warranty must include the
full model number and serial number of
the merchandiser.
H E AT I N G C H A R A C T E R I S T I C S
The heated upper glass surface provides even
heat transfer to hot food in heat tested
containers that are held in direct contact with
the glass top.
®
(76mm) from the top of unit,
# 8 7 5 • I N S TA L L AT I O N / O P E R AT I O N / S E RV I C E M A N U A L • 1.
C o u n t e r t o p M e r c h a n d i s e r
E L E C T R I C A L I N S TA L L AT I O N
®
Permanent wiring or electrical outlets for this
appliance must be installed by a licensed electrician
in accordance with local, country, or national codes.
Always position the appliance so the power supply
cord is easily accessible in case of emergency.
Plug the unit into a properly grounded receptacle
ONLY. Arcing will occur when connecting or
disconnecting the unit unless all controls are in the
OFF position.
For 230V units: To prevent an electrical shock
hazard between the appliance and other appliances
or metal parts in close vicinity, an equalization-
bonding stud is provided. An equalization bonding
lead must be connected to this stud and the other
appliances / metal parts to provide sufficient
protection against potential difference. The terminal
is marked with the following symbol.
NOTE: The appliance must be connected to an
electrical circuit that is protected by an external
GFCI outlet.
ENSURE POWER SOURCE
MATCHES VOLTAGE STAMPED
ON APPLIANCE NAMEPLATE
PH
3521030
PATENT NOS.
4595247
®
AT NO TIME SHOULD THE INTERIOR
OR EXTERIOR BE STEAM CLEANED,
HOSED DOWN, OR FLOODED WITH
WATER OR LIQUID SOLUTION.
DO NOT USE WATER JET TO CLEAN.
SEVERE DAMAGE OR ELECTRICAL
HAZARD COULD RESULT.
WARRANTY BECOMES VOID IF
APPLIANCE IS FLOODED.