ClearOne XAP TH2 Fiche technique - Page 2
Parcourez en ligne ou téléchargez le pdf Fiche technique pour {nom_de_la_catégorie} ClearOne XAP TH2. ClearOne XAP TH2 2 pages. Telephone interface
Également pour ClearOne XAP TH2 : Manuel d'installation et d'utilisation (20 pages)
Imprimer la page>
XAP TH2 BACK PANEL
>
INSTALLATION
Typical Installation in XAP 800 System
>
SPECIFICATIONS
Audio Performance
Conditions: Unless otherwise specified, all
measurements are performed with a 22 Hz to
22 kHz BW limit (no weighting). Transmit limiter
and Receive ALC disabled
Frequency Response: 250 Hz to 3.3 kHz ±1 dB
THD+N: <0.2% re max level
SNR: >62 dB re max level
Telco Line Echo Cancellation
Tail time: 31 ms
Null: 55 dB nominal
Expansion Bus In/Out
Proprietary Network
RJ-45 (2), 115.2 kbps,
110
kž
Impedance
Category five twisted-pair cable
80' (24 meters) maximum cable length between
any two PSR1212s, XAP 800s or XAP 400s
RS-232
DB-9 female
9,600/19,200/38,400 (default)/57,600 baud rate;
8 bits, 1 stop, no parity
Hardware flow control on (default)/off
>
CLEARONE LOCATIONS
Headquarters:
Salt Lake City, UT USA
Latin America
5225 Wiley Post Way
Suite 500
Tel: 801-974-3621
Salt Lake City, UT 84116
Tel: 801-975-7200
800-945-7730
Fax: 801-977-0087
© 2007 ClearOne Communications Inc. All rights reserved. Other product names may be trademarks of their respective owners. Information in this document subject to change without notice. 802-151-301 Revision 3.3
1
2
3
4
5
6
7
8
Control/Status
DB-25 female
Inputs: active low (pull to ground)
Outputs: open collector, 40 VDC max,
40 mA each
+5 VDC (300 mA over-current protected)
Telco Line
RJ-11
POTS (plain old telephone service) or analog
extension from a PBX
A-lead supervision provided
Telco Set
RJ-11
Connect analog telephone set
A-lead supervision provided
Transmit Input
Push-on terminal block, balanced, bridging
Impedance: >10
kž
Nominal Level: 0 dBu
Maximum Level: 15 dBu
Receive Output
Push-on terminal block, balanced
Impedance: <50
ž
Nominal Level: 0 dBu
Maximum Level: 19 dBu
EMEA
Tel: 44 (0) 1189 036 053
APAC
Tel: 801-303-3388
XAP
TH2
DATA SHEET
®
Device ID
4-position DIP switch
Set-up Software
G-Ware
Power Input Range
Auto-adjusting
100-240 VAC; 50/60 Hz
Power Consumption
15 W typical
Approvals
FCC, CSA, IC, CE, NOM, ACA, SABS,
JATE
Dimensions (LxDxH)
17.25" x 10.25" x 1.75"
43.8 x 26 x 4.5 cm
<