Alton STANLEY Manuel du propriétaire - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Alton STANLEY. Alton STANLEY 14 pages. 23 litre wet/dry vacuum

Imprimer la page

OPERATING INSTRUCTIONS

DRY PICK-UP

1. The filter must always be in correct position to reduce the risk of leaks and possible damage

to vac. Make sure that the filter is completely covering the filter cage. Make sure there are no

gaps between the filter and the lid. (See illustration). It is very important to assemble the filter to

the cage without allowing any possible leaks or tears. Any leaks will allow the picked up debris to

be blown out of the blowing port and back into the surrounding environment.

2. When using the vac to pick up very fine dust, it will be necessary to empty the dust tank and

clean or replace the filter at more frequent intervals to maintain peak vac performance.

NOTE:

A dry filter is necessary to pick up dry material. If you use the vac to pick up dust when the filter

is wet, the filter will clog quickly and be very difficult to clean. If the filter gets wet, replace it before

continuing to do dry pickups.

INSTALLING DISPOSABLE FILTER BAG

Slide the cardboard collar opening firmly onto the vacuum port deflector until it stops against the

deflector wall.

Position the bag so that it is distributed around the inside of the tank.

Replace and secure the power head onto the tank.

Disposable filter bag

WET PICK-UP

1. Remove reusable filter and replace it with foam filter when you do wet pickups.

2. This wet/dry vac is equipped with a float mechanism which will rise automatically to cut off the

airflow when the liquid in the tank reaches a predetermined level. When this happens, turn off vac,

unplug the power cord, and empty the dust tank. You will know that the float has shut the airflow

off because the suction ceases and the motor noise becomes higher in pitch due to increased

motor speed. The liquid capacity may vary with the rate of pickup.

IMPORTANT: To reduce the risk of damage to the vac, do not run motor with float in raised position.

Reusable filter

Clamp ring

Foam filter

Float in raised

position