Altos AcerAltos City1500 Manuel de l'utilisateur - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Altos AcerAltos City1500. Altos AcerAltos City1500 5 pages. Line-interactive ups
Imprimer la pageOVERVIEW
The UPS provides automatic voltage regulation for inconsistent utility power, and provides battery
backup during power outages, and ensures consistent power to your computer system.
HARDWARE INSTALLATION GUIDE
1. Your new UPS may be used immediately upon receipt. However, recharging the battery for at
least 8 hours is recommended to ensure that the battery's maximum charge capacity is achieved.
Charge loss may occur during shipping and storage. To recharge the battery, simply leave the
unit plugged into an AC outlet. The unit will charge in both the on and off position.
2. With the UPS unit off and unplugged, connect the computer, monitor, and any externally
powered data storage device (Zip drive, Jazz drive, Tape drive), etc. into the battery power
supplied outlets. DO NOT plug a laser printer, copier, space heater, vacuum, paper shredder or
other large electrical device into the battery power supplied outlets. The power demands of these
devices will overload and possibly damage the unit.
3. Plug the UPS into a 2 pole, 3 wire grounded receptacle (wall outlet). Make sure the wall branch
outlet is protected by a fuse or circuit breaker and does not service equipment with large electrical
demands (e.g. air conditioner, refrigerator, copier, etc. Avoid using extension cords.
4. Press the power switch to turn the unit on. The power on indicator light will illuminate and the
unit will "beep".
5. If an overload is detected, an audible alarm will sound and the unit will emit one long beep. To
correct this, turn the UPS off and unplug at least one piece of equipment from the battery power
supplied outlets. Wait 10 seconds. Make sure the circuit breaker / fuse is normal and then turns
the UPS on.
6. To maintain optimal battery charge, leave the UPS plugged into an AC outlet at all times.
7. To store your UPS for an extended period, cover it and store with the battery fully charged.
Recharge the battery every three months to ensure battery life.
BASIC OPERATION
Front panel
1. Power Switch
Press the switch for 2 seconds to turn the UPS ON or
OFF.
Mute setting: The audible alarm can be turned OFF or
ON by quickly pressing the power button twice. The
default setting is for the Alarm On.
2. Line Mode LED
The green LED will light when utility power is normal.
3. Battery Mode LED
The yellow LED will light when input power is
abnormal and the unit will work in battery mode.
4. Fault LED
The red LED will light when fault or over load occurs.
Page 2 of 5
Models:
1200/1500/2000
Models:
650/850
Version: 2020/07