ClearSpan 104903 Manuel d'instructions de montage - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions de montage pour {nom_de_la_catégorie} ClearSpan 104903. ClearSpan 104903 19 pages. Premium solar star greenhouse

Imprimer la page

After all parts are identified, the site is prepared, and the

Must Read document is read, assemble the base for the

greenhouse. The following steps describe one way to

assemble the greenhouse.

RECYCLED PLASTIC BASE BOARDS

ATTENTION: The longer boards may exceed 96" as

shipped. Measure and cut these to 96" if needed.

The door and non-door end base assemblies are

identical. Each includes two (2) lengths of plastic lumber:

•

1 plastic board at 32"

•

1 plastic board at 96"

The side base assemblies are identical. Each includes

three (3) lengths of plastic lumber:

•

1 plastic board at 44"

•

2 plastic boards at 96"

The boards for the recycled plastic base are positioned

end-to-end. The joints are not secured with any

brackets. See the following diagram.

44"

Door End

Door (or

Non-Door)

End

Visit www.ClearSpan.com for additional products and customer assistance.

Side

32"

Side Board

NOTE: The side base boards are positioned between (or

to the inside) of the door and non-door end base boards

as shown to achieve the required length and width.

This base can be placed on the site before or after

assembling the metal base.

The metal base is attached to the plastic lumber base

using A-Angle brackets after securing the panels to the

metal frame. This prevents placing the A-Angled

brackets in a position that interferes with the installation

of panel brackets.

ASSEMBLE THE METAL FRAME BASE

Locate the following brackets and tubes to assemble the

metal base frame:

Required tubes for each side/end:

Sides of Greenhouse:

Door End:

Non-Door End:

1. Assemble the metal frame as shown below:

Side Frame Tube

Door End

NOTE: Do not seat or secure the plain pipe tightly to the

swaged pipe at this time. The separate pipes must be

allowed to adjust outward during assembly to allow

proper panel fit.

104636 Corner Bracket

1 length @ 48" (plain)

2 length @ 99" (swaged)

1 length @ 25" (plain)

1 length @ 61" (plain)

1 length @ 27" (plain)

1 length @ 99" (swaged)

Non-Door End

4 of 18