ClearSpan R035B00011A Manuel - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} ClearSpan R035B00011A. ClearSpan R035B00011A 15 pages. Greenhouse door kits

Imprimer la page
ASSeMbLING THe DooR FRAMe CoMPoNeNTS (continued)
5.
With the door jambs attached, measure and mark the height of the
rough door opening. Consult drawing below and the Door Frame
Layout located in the Quick Start section located at the back of these
instructions. Measure from finished grade to underside of header.
6.
Locate the 105488120 header, measure the
distance of the door jambs and cut the header to required length.
7.
Using a metal saw, cut two 2" sections and bend the lip inward from
both ends of the door header as shown to the right (see photos F and
G). This creates two (2) lips and allows the header to be attached to
the door jambs. Open channel of the header points upward.
8.
Drill a 3/8" hole near each end of the header to create a drain hole for
the header. This helps prevent water from collecting inside the door
header (see photo H).
9.
Position the header so that the two (2) lips on each side overlap the
door jambs (see photo H) and align the bottom of the header with
vertical support marks made in Step 5.
10.
With the header level, attach the front and back of the header to
the door jambs using wafer head screws. Reinforce the header by
securing the bent lip to the vertical support using Tek screws as
shown in photo H. (or, customer-supplied bolts can be used.)
11.
After the door frame is square and assembled, secure the door jambs
in the ground using concrete.
NoTe: Concrete should remain at least 2"-4" below ground level so
that it does not interfere with construction, installation of other end
wall components (if equipped), or the operation of the door.
12.
After assembling the door frame, continue with the door assembly.
End frame and rafter are
not included with any
door kit.
*Not shown
to scale.
Door jamb in
concrete.
Ground
Level
6
Door Frame Assembly
outside-to-outside
105488120
Header (cut to length)
H
92-1/2"
(bottom of header to the
top of finished grade)
96-1/2"
(inside-to-inside)
Concrete
Bend this
section inward
ToP VIeW
Tek screw
Drain Hole
H
Ground Level
Revision date: 05.28.10
F
Cut along
dotted lines.
G
Wafer
Head
Screws
H