EdgeWave iPrism Manuel du matériel - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel du matériel pour {nom_de_la_catégorie} EdgeWave iPrism. EdgeWave iPrism 12 pages. Models 15h;models 25h;models 35h;models 55h;
models 105h;
Également pour EdgeWave iPrism : Installation sur un rack (3 pages)
Imprimer la pageLEDs and Lights
The LEDs and lights on the iPrism control panel keep you informed of the system status. The
following LEDs and lights are available on the h-Series:
UID: Unit identifier. Pressing the UID button illuminates an LED on both the
front and rear of the appliance so you can locate the appliance in a large stack
configuration. The LED remains on until the button is pushed a second time.
Another UID button on the rear of the appliance serves the same function.
U: Universal Information LED (models 35h, 55h, and 105h). When this LED
blinks red quickly, it indicates a fan failure; when blinking red slowly, it indicates
a power failure. When on continuously, it indicates an overheat condition,
which may be caused by cables obstructing the airflow in the system or the
ambient room temperature being too warm. Check the routing of the cables
and make sure all fans are present and operating normally. You should also
check to verify that the appliance chassis covers are installed. Finally, verify
that the heatsinks are installed properly (if you need assistance with this,
contact Technical Support). This LED will remain on or flashing as long as the
indicated condition exists.
NIC2:
Model 15h - Flashing indicates network activity on the external interface port.
Models 25h, 35h, 55h, and 105h - Unused.
NIC1:
Model 15h - Flashing indicates network activity on the internal interface port.
Models 25h, 35h, 55h, and 105h - Flashing indicates network activity on the
management port.
HDD: Indicates IDE channel or SATA activity when flashing.
Power: Indicates power is being supplied to the system's power supply unit(s).
This LED should normally be illuminated when the system is operating.
3
iPrism Hardware Guide