ClearWater OzoneMAX OZ-50 Manuel d'installation et d'utilisation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} ClearWater OzoneMAX OZ-50. ClearWater OzoneMAX OZ-50 8 pages. Vacuum-ultraviolet pool ozone systems

Imprimer la page

Power Source/

TimerBox

The OzoneMAX system is comprised of a power box and a venturi injection kit with manifold, which

needs to be installed at the very end of the return line (after the filter, ionizer electrode chamber,

heater, etc.).

The ozone unit will need to be installed to a post or wall within six (6) feet of a 115 or 220VAC timer,

electrical box or a 115V receptacle. This location will need to be within eight (8) feet of location of the

venturi injector. This location should be mounted at least one (1) foot above maximum water level

and preferably out of direct sunlight. The ozone unit should be no closer than five (5) feet from a

body of water.

Mount the OzoneMAX unit to a post or wall using the four mounting screw holes in the enclosure

base. The unit may be mounted horizontally or vertically, however it is recommended that the vent

holes not face upward and be directly exposed to rainfall. The location of the box must be within

eight (8) feet of the location of the venturi, which is plumbed on the return line. The unit should be

mounted at least one (1) foot above maximum water level and preferably out of direct sunlight. The

power box should also be located no closer than five (5) feet from a body of water.

It is strongly recommended to add a protective shade cover to keep the unit out of direct

sunlight if possible.

C. Tools & Materials Required

• Bullet Level

• Hacksaw or Pipe Cutter

• PVC Cleaner/Primer

• Screwdrivers, Flat & Phillips

D. Site Survey

OzoneMAX Unit

within 6 feet

E. Installing the Power Box

• Drill & Drill Bits

• PVC Cement

• Utility Knife

• Screws & Anchors

within 8 feet

Venturi Injector