EDIATec ECW100 Manuel d'installation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} EDIATec ECW100. EDIATec ECW100 14 pages. Collision warning unit
Également pour EDIATec ECW100 : Manuel d'utilisation (15 pages)

Imprimer la page
EDIATec ECW100 Manuel d'installation
5. Housing
The front of the housing has fore threads, so that ECW100 can easily be secured by fore
M4 screws (no more than 10 mm long).
On the rear side there are two distance holders on the D-Sub-15 Connector. Do not
remove these distance holders.
By opening the housing, all guarantees relating to the equipment become null
and void.
ECW100 is not sealed and care should be taken not to allow ingress of solid particles or
liquids. Should the unit become wet, it must be thoroughly dried prior to use.
Condensation may occur if the unit is subjected to sudden massive cooling. The housing
should only be cleaned with a slightly moist nonabrasive cloth without any cleaning
agents. The housing can be damaged by scratches and abrasion.
The front housing is black to minimize glare and has been tested at temperatures from
-10°C to +60°C and should be protected from excessive direct or indirect solar heating.
The unit should not be exposed to strong locally focused solar radiation. Care should be
taken when the cockpit canopy is open (lens effect fire hazard).
6. Connectors
The rear face has an SMA socket for a λ/2
dipole radio antenna [RF], a D-Sub connector
[D-SUB 15] for power and data and a MCX
socket for an active GPS antenna [GPS].
Page 5