ArtFox BEAM 7R Manuel - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} ArtFox BEAM 7R. ArtFox BEAM 7R 10 pages.

1. Installation of computer light.

Using eight M10 size bolts, through making use of bracket that

owned by computer light install. Make sure the firmness of

installation, in case swing or glide happen when it works. Each

weight of computer light is 20.5KG more or less. Before installation,

it should be ensure if frame can support the weight. For safety, a safe

chain should be through the side handle of lighting body.

Notice: please don't use the die down yoke of computer light to rise,

to lower, and move it.

2. Installation of lamp.

loosen plastic body which locate in luffing structure of computer

lighting body, and strengthen screw of right-and-left cover shell, then

open the cover forth gently, at the tail of shine lamp, screw off four

coppery screw and move metallic gobo flag and heat guard of two

sides, then can replace lamp. When install it, please use 5R 200W

lamp. Pay attention to screw down the screw of two sides of lamp, or

it cause high voltage short circuit and discharge for poor contact. It

influence service life of lamp, and damage components of circuit

board. After finish it, please strengthen the metallic gobo flag and

heat guard of two sides of lamp firstly. Then using adhesive tape to

fold covering shell, and strengthen screws of right-and-left of it.

NSK light products are provided with high voltage modulator tube

what has exterior igniter. When operate these modulator tubes, it must

be careful, and should read the instruction of modulator tube that offer

by manufacturer before operation.

Warning 1: Don't forget install metallic gobo flag and heat guard

that beside the lamp or thermal radiation is easy to bake the plastic

shell distortion. Seriously, it will raise fire alarm. Manufacturer will

not responsible for these losses.

Warning 2: Modulator tube will reach to a high temperature when

it works, and the trait of gas discharge lamp can not intermittent

power supply. It must cool at least 15 minutes to work again after

power supply cut off, or it will induce high pressure discharge, short