AIMS Power PRM1000W24120S Manuel d'utilisation - Page 10
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} AIMS Power PRM1000W24120S. AIMS Power PRM1000W24120S 16 pages. 1u rack
Imprimer la page
Important
1) Input Terminal (12V, 24V or 48V)
Prior to any connections make sure you match the battery voltage to the inverter input voltage. You will probably notice an arc when
connecting a discharged or new power inverter to your batteries. Make sure to connect battery ( ) to Black and battery ( ) to Red.
Tighten terminals. In case of extreme vibration, go back and verify terminals are tight.
2) Inverter on switch/LED
This is the main unit power switch. When this is turned off, the inverter is off. When turned on, the inverter is on.
This LED always lights up when the power switch is on or this inverter is in operation.
3) Overload protection LED's
This LED should not illuminate unless an error occurs. The error may be temporary, such as an overload. It may also indicate a
permanent failure. If it is lit, try disconnecting all loads, and reset inverter.
4) Inverter
This lamp is on whenever unit is connected to battery and not in city power mode.
Even when inverter on switch is off and no city power is present.
5) City power
This lamp is always turned on when using city power.
6) 120Vac outlet
It is 120Vac power outlet.
This product uses city power as an optional input. Ensure city power is not connected to the output of this inverter
or it will be permanently damaged and may pose a shock or fi re hazard. Refer to the manual for proper installation
and operation
Warning
10