dji E1200 Standart Manuel de l'utilisateur - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} dji E1200 Standart. dji E1200 Standart 9 pages.

3. Connecting the ESCs

Tools Required

Tools: Power hub, electric soldering iron and soldering tin

Use: To solder each ESC's power cable to the power hub

1) Please solder each ESC to the power pads on the power hub as shown in

the figure below. Make sure that the solder is firmly attached to the power

pads and that there is no possibility for a short circuit. The power cable is a

coaxial power cable. Do not damage the protector on the red cable to avoid

short circuits.

2) Connect the signal cable to your controller. The signal cable's orange wire

is for the control signal, the signal cable's brown wire is for the GND, and

the red wire is reserved.

3) Connect the motor to the ESC. Test the motor and ensure that the rotation

direction of each motor is correct. If not, switch the position of any two

cables connecting the motor to the ESC to change the rotation direction.

ESC signal cable

To the controller

Power hub

Make sure that there are no open circuits or exposed wires that can

cause short circuits.

It is recommended that you solder a power connector onto the power hub.

4. Mounting the Motors

Mount each motor to a frame arm according to the motor dimensions and the

size of the assembly hole.

4×M3 Thread depth 4 mm

18 mm

48.7 mm

ESC

Power cable

Take the power hub in the figure for example. The outer power pads are for the

GND cables, and the inner power pads are for the power cables. The red core

of the coaxial power cable is positive, and the shielding layer of the coaxial

power cable is negative. Make sure to solder them correctly. Try to solder the

cables firmly to the power hub at the proper length (the wires should be just

long enough to reach the soldering point, face outwards, and should not be

bunched up in front of the soldering point).

4×M3 Thread depth 4 mm

30 mm

The screw size is M3. Mount the

motors using the appropriate

screws.

Note the thread depth and the

size of the screws. Using screws

that are too long or too large may

damage the motor.

Motor