dji Matrice 600 Pro Manuel de l'utilisateur - Page 13
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} dji Matrice 600 Pro. dji Matrice 600 Pro 16 pages.
Également pour dji Matrice 600 Pro : Manuel de démarrage rapide (8 pages), Manuel de référence rapide (9 pages)
Imprimer la page
MATRICE 600 PRO User Manual
Charging the Intelligent Flight Battery
The Matrice 600 Pro is shipped with a DJI Hex Charger. It can charge up to six Intelligent Flight
Batteries and two remote controllers simultaneously.
1. Connect the Hex Charger to a power outlet (100-240V, 50/60Hz) with the power cable.
2. Insert the Intelligent Flight Battery into the battery port to begin charging.
3. When the LED lights on the Intelligent Flight Battery turn off, charging is complete and the device
can be disconnected from the Hex Charger.
Place the Hex Charger on a flat and stable surface when in use. Ensure the device is
properly insulated to prevent fire hazards.
DO NOT block the heat vent when using the Hex Charger to ensure that heat can be
properly dissipated.
DO NOT attempt to touch or expose the metal terminals on the Hex Charger.
Clean the metal terminals with a clean, dry cloth if there is any noticeable buildup.
The two remote controller ports are connected in parallel with the battery ports as shown in
the figure above. As a result, charging a remote controller together with an Intelligent Flight
Battery on the corresponding port will require longer charging time.
Air cool the Intelligent Flight Battery after each flight. Allow its temperature to drop to room
temperature before charging.
The charging temperature range is 5° to 40° C. The battery management system will stop
the battery from charging when the battery cell temperature is out of range.
Battery Level Indicator While Charging
LED1
LED2
12
©
2016 DJI All Rights Reserved.
LED3
LED4
Battery Level
0%~25%
25%~50%
50%~75%
75%~100%
Fully charged