dji FlameWheel 450 Manuel de l'utilisateur - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} dji FlameWheel 450. dji FlameWheel 450 9 pages.
Également pour dji FlameWheel 450 : Manuel de l'utilisateur (8 pages)

Imprimer la page

FlameWheel 450 User Manual

Propeller Mounting Description

Attach the propeller with a silver nut onto the

counter clockwise motor.

Silver nut (9450)

Lock: Tighten the propeller by rotating

it in this direction.

ESC and Motor Wiring Description

1. Please solder each ESC to the power pads on the bottom board as shown in the figure

below. Make sure that the solder is firmly attached on the power pads and that there is no

possibility for a short circuit. The power cable is a coaxial power cable. Do not damage the

protector on the red cable to avoid short circuit. The red core of the coaxial power cable

is positive, and the shielding layer of the coaxial power cable is negative. Make sure to

solder them correctly at the proper length (the wires should be just long enough to reach

the soldering point, face outwards, and should not be bunched up in front of the soldering

point).

2. Connect the signal cable to your controller. The orange wire of the signal cable is for the

control signal; the brown wire of the signal cable is for the GND.

3. Connect the motor to the ESC. Test the motor and make sure the rotation direction of each

motor is correct. If not, switch the position of any two cables that are connecting the motor

to the ESC to change the rotation direction.

Motor

ESC cable

ESC

Power cable

Attach the propeller with a black nut onto the

clockwise motor (which has an indent on the

screw).

Black nut (9450 cw)

Unlock: Remove the propeller by

rotating it in this direction.

To the controller

Connect to the battery