dji DR16 Manuel de l'utilisateur - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} dji DR16. dji DR16 5 pages. 2.4g rc system
Également pour dji DR16 : Manuel de l'utilisateur (7 pages)
Imprimer la page
The LED Indicator Status of DR16 Receiver
LED Indicator
Solid
—
Solid
—
Blinking
Blinking
Default Channel Mappings of DT7 & DR16
MODE 1
Receiver
Channels
A
E
T
R
U
X1
X2
Using the RC SYSTEM Assistant
The RC SYSTEM Assistant is used to configure the DT7 remote controller, upgrade its
firmware, select the control mode and calibrate the sticks.
Download, Installation & Connection
1. Download it from DJI website (http://www.dji.com/product/dt7-dr16-rc-system) or scan
the QR code below to get the download link.
2. Download the driver and RC SYSTEM Assistant, then install the driver and software on
your PC.
3. Turn on the remote controller and connect it to your PC by using the Micro-USB cable.
4. Run the RC SYSTEM Assistant. Wait for the remote controller to connect to the Assistant.
When the connection indicator is solid green and the communication indicator blinks
blue, it has connected.
Firmware Update
1. On the [Info] page, click Latest Version to download and install any updates.
2. Power cycle the remote controller after finishing the update. Check the firmware version
on the [Info] page, if the RC SYSTEM Assistant shows the latest version, then the update
was successful.
Stick Mode Configuration
1. Select your custom control mode in the Stick Mode bar on the [Main] page.
2. Power cycle the remote controller, push both sticks and observe whether the cursors in
the correct channels are moving. This will confirm stick mode configuration.
Sticks Calibration
1. On the [Main] page, click the "Calibration" button to calibrate the sticks following prompts.
2. Calibrate the remote controller after every firmware upgrade or configuration, and calibrate
on a regular basis.
The content is subject to change.
Download the latest version from
http://www.dji.com/product/dt7-dr16-rc-system
If you have any questions about this document, please contact
DJI by sending a message to [email protected].
Status
The remote controller is linked with the receiver.
The remote controller is turned off and there is no 2.4 GHz
signal around.
The receiver is ready for linking.
There is a 2.4 GHz signal nearby, but the remote controller is not
linked with the receiver.
Remote Controller
Channels
J1
J2
J3
J4
S1
LD
S2
MODE 2
Receiver
Channels
A
E
T
R
U
X1
X2
Remote Controller
Channels
J1
J2
J3
J4
S1
LD
S2