dji AC001 Manuel de démarrage rapide - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} dji AC001. dji AC001 9 pages.

Compliance Information

FCC/ISEDC Compliance Notice

This device complies with Part 15 of the FCC Rules and ISEDC licence‐exempt RSS standard.

Operation is subject to the following two conditions: (1) This device may not cause harmful

interference, and (2) This device must accept any interference received,including interference that

may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could

void the user's authority to operate the equipment.

Cet appareil est conforme à la partie 15 des règles de la FCC et à la norme RSS exonérée de licence

ISEDC.

L'opération est soumise aux deux conditions suivantes: (1) cet appareil ne peut pas causer

d'interférences nuisibles, et (2) cet appareil doit accepter toute interférence reçue, y compris les

interférences qui peuvent causer un fonctionnement indésirable.

Toute modification ou modification non expressément approuvée par la partie responsable de la

conformité pourrait annuler l'autorisation de l'utilisateur d'utiliser l'équipement.

This device has been tested and found to comply with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses and can radiated

radio frequency energy and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation If this

equipment does cause harmful interference to radio or television reception, which can be determined

by turning the equipment off and on, the user is encouraged to try to correct the interference by one

or more of the following measures:

‐Reorient or relocate the receiving antenna.

‐Increase the separation between the equipment and receiver.

‐Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

‐Consult the dealer or an experienced radio/TV technician for help.

RF Exposure Information

This device(OSMO ACTION; model AC001) is compliance with SAR for un‐controlled FCC and ISED

exposure limits and had been tested in accordance with the measurement methods and Procedures

specified in IEEE1528 and IEC 62209, this equipment should be installed and operated with minimum

distance 1 cm between the radiator and your face when close to eye operation.

This device and its antenna(s) must not be co‐located or operating in conjunction with any other

antenna or transmitter.