Artillian 1RMTBWM Manuel d'installation et d'utilisation - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Artillian 1RMTBWM. Artillian 1RMTBWM 6 pages. Artillian rops mounted tool bar wall mount

Imprimer la page

FEATURES

The Artillian ROPS Mounted Tool Bar Wall Mount allows for one or more Artillian ROPS Mounted Accessories to

be attached to a flat wall. Additional Tool Bars allow for additional accessories.

The innovation of the design is that any of the compatible accessories can be installed or removed from the Tool

Bar in seconds, without the use of tools.

One job may require a toolbox filled with various hand tools. Another might necessitate a tool rack holding

assorted long-handle yard tools or maybe a chainsaw mount and fuel can holder.

With the effortless installation and removal of each accessory, you won't waste any time setting up your trailer to

carry the specific tool required for the job!

ATTACHING ACCESSORIES:

1. Figure 1 shows an example of a toolbox installed

on a Tool Bar (shown on a tractor 2-Post ROPS).

2. To install an accessory, have both cam levers

rotated UP, then place onto the Tool Bar. See fig.

3. To secure the accessory to the mounting bar,

rotate both cam levers DOWN until they cam over.

See fig. 3.

NOTE: The accessory can be locked to the Tool Bar by

inserting a padlock through the holes in the mounting bracket

where shown.

4. To remove an accessory, rotate both cam levers

UP and lift the unit off of the Tool Bar.

OPERATION

Tool Bar fasteners may loosen up over time due to

repeated loading and unloading of accessories. It is

recommended that the fasteners are checked and

retightened, as required, regularly.

Multiple Tool Bars can be added to a wall to allow for

more accessories to be attached at a time.

FEATURES AND OPERATION

Fig. 1 (example of attaching a tool box)

rotate both cam levers up

to install an accessory

Fig. 2 (cam lever in the open position)

padlock holes

rotate both cam levers down

to secure the accessory

Fig. 3 (cam lever in the closed position)

4 of 6