Artillian 1UTVTB Manuel d'installation et d'utilisation - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Artillian 1UTVTB. Artillian 1UTVTB 8 pages. Artillian utv bed mounted tool bar

Imprimer la page

1. Park the vehicle on a flat, level surface.

2. Once a mounting configuration has been chosen, make

a temporary mark on the vehicle bed for locating where

to fasten the mounting brackets. It is recommended that

you take measurements off of a common feature on the

bed so that the brackets will be level with each other

and centered.

3. Choose the desired orientation (facing outside the bed

or inside). Note: If installing the Artillian UTV Mounted

Tool Rack, outside orientation is REQUIRED.

4. The included hardware kit contains various length

screws. Choose the best length for your application,

ensuring that the screw protrudes through the end of

the nut. If the appropriate length screws are not found

in the supplied kit, it is up to the discretion of the

installer to procure 5/16-18 screws that are the

appropriate length for the application. Backer plates

have been provided for through bolting applications.

INSTALLING ON 1" SQUARE VEHICLE BED RAILS

(Most Kawasaki Beds)

5. Use the 1" square tube clamps (provided) to clamp the

mounting brackets to the tube. Ensure that mounting

brackets are level to each other, perpendicular to the

bed rail, and not touching the plastic. Tighten fasteners

using an alternating pattern. See Fig. 5

INSTALLING ON FLAT METAL BED RAILS

(Most Club Car 4X4's)

C-Clamp the mounting brackets in the desired location

and install the tool bar onto the brackets. See Fig. 6

Note: if the bed rails have a return flange on top, ensure that the

chosen location will allow access to the fasteners on all sides.

7. Test fit an Artillian Tool Bar Accessory onto the tool bar

to ensure that the cam lever latches can be fully locked

without interference with the bed. Relocate the

mounting brackets, if required.

8. Use the holes in the mounting brackets as a template

for where to drill the vehicle. It is recommended to use

the two sets of top and bottom holes in the bracket, but

any (4) of the holes can be used. If center holes are

selected, use a screwdriver, or an awl, to poke holes

thru the foam. Drill 11/32" holes through the bed.

Fasten with backer plates on opposite side. Tighten

fasteners using an alternating pattern. See Fig. 8.

INSTALLING ON FLAT METAL BED RAILS WITH

WELDED-IN TUBES

(Most Kubota RTV's)

Follow Steps 6 & 7 to find the desired bracket location.

10.

With a screwdriver, or an awl, poke holes thru the foam

covering the center holes. Use center holes in mounting

brackets as a template to drill 11/32" holes through the

tube in the bed. Tighten fasteners. See Fig. 9

KIT INSTALLATION

1" Square Tube Clamps

1" Square Vehicle Bed Rail

(Driver's Side)

Fig. 5

Mounted to Vehicle Bed Rail, Facing Outwards

Flat Vehicle Bed Side

(Driver's Side)

Fig. 6

Mounted to Flat Vehicle Bed, Facing Outwards

Flat Vehicle Bed Side

(Driver's Side viewed From Passenger's)

Fig. 8

Mounted to Flat Vehicle Bed,

Facing Outwards (viewed from inside of bed)

Flat Vehicle Bed Side w/ Welded Tube

(Driver's Side)

Fig. 9

Mounted to Flat Vehicle Bed w/ Welded Tube,

Facing Outwards

4 of 8