Artillian 1UTVTBPR Manuel d'installation et d'utilisation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Artillian 1UTVTBPR. Artillian 1UTVTBPR 8 pages.

Imprimer la page

FOR INSTALLATION ON GRAVELY ATLAS JSV 3400SD

1. Position the left side tool bar mounting bracket on top

of the left side bed rail centering it both left to right

and front to rear and clamp in place. See figure 13

below.

2. Using the tool bar mounting bracket as a template,

mark the center of the (6) slots.

3. Remove clamps and set aside the tool bar mounting

bracket. Drill the vehicle's bed rails where previously

marked.

4. Debur holes and any sharp edges. Paint bare metal

areas to prevent future oxidation.

5. Fasten the left side tool bar mounting bracket using

the (6) supplied 5/16" x 1" bolts, (6) 5/16" washers

and (6) 5/16" flange nuts. See figure 17.

6. With assistance, install 42" long tool bar, tube

clamps, and 32" long UTV Tool Rack Vertical Tubes

(supplied in the UTV Bed Mounted Tool Rack) on left

side of bed. Use (4) of the supplied 5/16" X 1" screws

to secure. When placing the tool bar, make sure to

leave a 1" gap between the end of the tool bar and

the ROPS of the vehicle. Repeat on right side. See

Fig. 9 found on the previous page.

Note: Make sure that the (2) threaded inserts of the

Vertical tubes are placed on the top/inside of the

assembly.

7. Repeat steps 1-6 on the right side of the vehicle.

8. See Installation Manual for Artillian UTV Bed Mounted

Tool Rack (1UTVRK) to complete installation of the

tool rack.

Note: The backing plates and 5/16" x 6" long bolts may

be discarded if tool bar has been installed on a Gravely

vehicle.

Mark the

Center of Slots

KIT INSTALLATION

Front of Vehicle

Tool Bar Mounting

Bracket

Fig. 13; Top View of Bed - Tool Bar Mounting

Bracket Orientation on Gravely Vehicle

5/16" x 1" Bolts

5/16" Washers

Fig. 17; Tool Bar Mounting Hardware

5 of 8

5/16" Nuts

Front of Vehicle

Bed Rail