Custom Crimp CC200 Manuel de l'opérateur - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} Custom Crimp CC200. Custom Crimp CC200 18 pages. Dial micrometer style adjustment
Également pour Custom Crimp CC200 : Manuel de l'opérateur (17 pages)

Imprimer la page

INITIAL SET UP & MAINTENANCE

Do not lift the machine by the crimper head.

Lift with a fork lift under the tank.

Mount the crimper on a sturdy surface.

Check electrical circuit to be certain that it matches the crimper

requirements shown on the tag attached to the crimper cord.

Electrical Requirements:

230 Volt 3 Phase Current (Standard)

440 Volt 3 Phase Current (Optional)

230 Volt single phase (Optional)

DO NOT RUN CRIMPER ON AN EXTENSION CORD.

Check to be certain that the motor rotates in the direction of the arrow

shown on the motor housing. If motor rotation is opposite of the direction

of the arrow, reverse any two hot wires in the electrical plug.

(NOTE: THIS IS APPLICABLE TO 3 PHASE CIRCUITS ONLY).

Damage to the pump can result if the motor does not rotate in the

correct direction.

Check the oil level in the sight glass on the rear of the crimper. 8 U.S,

gallons of ISO 46 hydraulic oil are required to completely refill the tank.

Oil can be drained from either of the two ports at the bottom of the tank.

An additional oil cooler, while not normally required, can be plumbed

into the two ports at the rear of the crimper.

Front Flange Bolts: Periodically, every 6-12 months depending upon

usage, the front flange bolt torque should be checked. The correct torque

is 332NM (245 Ft-Lbs).

Lubricate the crimping head after each 100 crimping cycles or at the

start of each shift if the crimper is used in a production setting.

•

Bring the master dies to the fully closed position and lubricate the die

fingers through the 8 lubrication fittings in the front flange face.

•

Bring the dies to the fully open position and lubricate all 8 fittings again.

Use CRIMPX Die Lubricant Grease or high quality moly-disulfide grease.

Failure to do so may result in damage to the wearing surfaces.

Innovating SMART Hose Assembly Solutions Since 1979