Custom Dynamics PB-DS2-14-CON Instructions d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} Custom Dynamics PB-DS2-14-CON. Custom Dynamics PB-DS2-14-CON 2 pages. Led turn signals

Imprimer la page

Questions? Call us at: 1 (800) 382-1388 M-TH 8:30AM-5:30PM / FR 9:30AM-5:30PM EST

Installation Instructions - Page 2

3. Remove the mounting studs on the fork with a 9/16" wrench or deep well

socket.

4. Repeat steps 1 through 3 on the opposing side turn signal assembly.

5. Plug in the male connector of the of the ProBEAM® Dynamic Strips™ harness

into female connector on the turn signal factory wiring harness.

6. Push the tun signal connectors into the hole in the fork frame

7. Install the ProBEAM® Dynamic Strips™ onto the fork frame and secure with

the provided 5/16" button head bolts and washers. The LEDs should be on

the bottom of the ProBeam® Dynamic Strips™ when mounted to the fork.

Repeat step for the opposing side.

8. Run the 4 way hazard flashers, with the ignition in the off position, for 3

minutes to sync BCM with the ProBEAM® Dynamic Strips™. After you have

sync'd the BCM

9. Check all lighting for proper operation in all modes.

05/2021