artisan ART-ISB Manuel d'installation - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} artisan ART-ISB. artisan ART-ISB 3 pages. Infrared sear burner
Using a screwdriver, remove the electrode screw
•
and pull the U-BURNER electrode out SLOWLY.
There is additional ignition wire located inside
the front of the grill in order to pull the connector
approximately 1" outside of the front wall.
(See Figure 3)
Remove the electrical wire connected to the
•
back of the U-BURNER Electrode by gently
pulling and moving from side to side.
DO NOT let go of this wire as you will need to
reconnect it to the SEAR BURNER Electrode.
Connect the Electrode wire to the new SEAR
•
BURNER Electrode by pushing it into the spade
connector at the end.
Install the new SEAR BURNER Electrode with
•
the tip facing "UP" using the same screw that
you previously removed.
(See Figure 4)
This new SEAR BURNER Electrode has dual
•
tips. At this point, you should be able to test the
spark by pressing the ignition button in the front
panel. Verify that the spark is good by maintain-
ing a 1/8" GAP between tips.
Replace the ignition module battery if necessary
as shown in the grill's manual.
Insert the SEAR BURNER by installing the front
•
tube first and slightly rotating the burner around
the tips of the electrodes as you push the burner
forward towards the control panel.
(See Figure 5)
SCREW
Figure 3
SCREW
SEAR
BURNER
U-BURNER
ELECTRODE
SEAR BURNER
ELECTRODE
Figure 4
Figure 5
2