DK Digital DCR-4000 Manuel du propriétaire - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} DK Digital DCR-4000. DK Digital DCR-4000 20 pages. Stereo cd / mp3 car radio

Imprimer la page

10. MONO / STEREO

VHF stations normally broadcast in stereo. In areas where reception is difficult, this can lead

to interferences or increasing noise. It is then recommended to switch to mono in order to

decrease the noise and to increase the playback quality.

11. LOCAL / DX

Via this parameter you can influence the threshold of the channel search. Select "LOCAL" in

areas with channels with high transmitting power. The channel search will then only stop for

channels with high transmitting power. Select "DX" in areas with channels with low

transmitting power. The channel search will then stop for channels with low transmitting

power as well.

Radio mode

When switching it on the device runs in the radio mode. To switch to radio mode from other

operation modes, push the MODE button so many times until a frequency or the name of a

radio station is shown in the

What is RDS?

RDS (Radio Data System) is a system for transmission of additional information with the FM

radio programme transmitted in many European countries. RDS radio tuner can filter this

information from the transmit signal and use it for various functions. This device uses the

following RDS

functions:

—

Display of the name of the radio station

—

Display of programme type (PTY) and search for programme contents

—

Display of time

in the display. When you are tuned to a station that transmits RDS information, the name of

the radio station is automatically

Selecting the frequency band

Press the BAND button several times to select the desired frequency band: FM1 / FM2 / FM3

= FM, MW 1 / MW 2 = AM (Medium wave).

Searching for radio stations

Manual tuning

Press the TUNE/TRACK button

higher or lower than the one shown in the

Search run to the next radio station

When you hold down the TUNE/TRACK button

backward or forward until a strong enough signal is received. The search run will stop there

and play the radio station. FM stations normally transmit in stereo. Provided the signal

received is strong enough, the programme is played in stereo and the

display lights

up.

Area Scan

Briefly press the SCN button to start a search run that is constantly scanning the current

frequency range. The car radio will play every radio station it finds for a few seconds before

display.

displayed.

repeatedly to search step by step for a frequency

display.

for one second, search run will start

symbol in the