DK SONIC DK-1900TS Manuel de l'utilisateur - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} DK SONIC DK-1900TS. DK SONIC DK-1900TS 9 pages.

OPERATION

1. Fill the stainless steel tank with cleaning solution; Plug the power lead into

grounded outlet; Turns on the switch on the side of the ultrasonic cleaner , After

power-on, the LCD screen displays the preset temperature (25℃ in default), actual

environmental temperature, preset time - (3 minutes in default), actual time,

frequency and power ratio.

2. Ultrasonic Frequency Setting: Press the ultrasonic frequency switch to select the

ultrasonic frequency you need (40Khz, 80Khz, Dual frequency 40Khz &80Khz )

*Note: Only after preset the cleaning time in frequency 40Khz and cleaning time in

frequency 80Khz, then you can select dual frequency (40Khz& 80Khz)

3. Time setting: Press the ultrasonic time "+/- " buttons once to add or decrease

one second cleaning time; keep pressing the ultrasonic "+/- " button to make the

time setting to be added or decreased by minute. If preset time display "Cont",

then the machine ultrasonic time is in "always on" mode.

4. Temperature Setting: 1℃ can be added or decreased by pressing the

temperature "+/-" button by once, and the preset temperature can be added or

decreased continuously by keeping pressing the heating "+/-" button.

NOTE: Do not pour water out until it's cooling, because of hot water will hurt you

and also empty burn will damage the machine itself.

5. Ultrasonic Power Adjustable : Press the two buttons "

Switch + " and "Ultrasonic Power Switch - " at the same time , the power percent

display start flash, then press "power +" or ""Power-" button to adjust the ultrasonic

power you need.

6. Ultrasonic Cleaning modes: Common, Degas, Pulse, Turbo Sweep,

Power Sweep. Five cleaning modes can be chosen to clean different stuffs.

7. Ultrasonic switch:

Press it to start ultrasonic ,Press it again to be pause state.

Ultrasonic Power