ALTUS Du350 Manuel du produit - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel du produit pour {nom_de_la_catégorie} ALTUS Du350. ALTUS Du350 18 pages.

Imprimer la page

Duo Series

Doc. Code: CE113100

Fast Digital Outputs

Number of outputs

Maximum current per point

Output type

Maximum frequency of pulse

generation

Minimum pulse bandwidth

@ 24 Vdc

Status indication

Protection

Operation voltage

Insulation

Output impedance

Terminal block configuration

Output modes

Maximum number of used

outputs

Functions performed via

software

Access way to fast outputs

registers

Notes

Maximum current per point: the fast transistor output has no overload protection. If output protection is necessary external

fuse to the product should be used.

Functions performed via software: variation of 1 in 1 Hz or 1 in 1 % for frequency settings and duty cycle respectively.

ATTENTION:

During the product power on, fast outputs may change its state for approximately 100 us.

Altus S. A.

DU350, DU351

2 fast:

Q00 and Q01

0.5 A

Transistor ("Source" type)

50 kHz

Minimum external load

No load

1000 

50 

Through reserved fixed operands

TVS diode in all transistor outputs

10 to 30 Vdc

2000 Vac per one minute between each output group

2000 Vac per one minute between output group and logic circuit

700 m

Fast outputs are located in the connector of digital output insulation

group 0. The connector is made up of a terminal block for each

output, a terminal block to the common contact (power supply) and a

0 V terminal block reference.

Q00 to Q01 – fast output 0 to 1 of insulation group 0

C5 - Reference (0 V), insulation group 0 (shared with the relay

(DU351) / transistor (DU350) outputs)

C6 – Power supply, insulation group 0 (shared with the transistor

outputs (DU350)). Maximum voltage 30 Vdc

PTO, VFO and PWM

PTO

Writing of the value (number of

pulses) to be generated

Writing of the number of pulses

to be generated in the

acceleration / des-acceleration

Start / end of the outputs

operations

Fast outputs diagnostics

Monitoring of the current state of

fast outputs

In reserved fixed operands

DU350, DU351

Minimum pulse time

20 s

4 s

2 s

VFO/ PWM

Writing of the frequency value to

be generated in Hz (1 Hz to 50

kHz)

Writing of the outputs Duty-

Cycle from 0 to 100 %

Start / end of outputs operations

Fast outputs diagnostics

Revision: G