DK2 Power OPG888E Manuel de l'utilisateur - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} DK2 Power OPG888E. DK2 Power OPG888E 17 pages. Stump grinder

Imprimer la page

PART III: Operating the Stump Grinder

It may be helpful to better familiarize yourself with the features of your Stump Grinder

before beginning the steps outlined in this chapter.

WARNING

A. Read and understand all instructions, safety precautions, and/or warnings listed in

"PART I: General Safety Rules" before operating the Stump Grinder. If any doubt or

question arises about the correct or safe method of performing anything found in this

manual, please contact DK2POWER.

When operating the Stump Grinder, make sure you are standing in the safe operating

area (OPERATOR ZONE). Never place any part of your body into a position that

causes an unsafe operating condition.

C. Before operating the Stump Grinder, always wear protective gear, including safety

goggles, hearing protection, tight-fitting gloves without draw strings or loose cuffs, and

steel-toed shoes.

D. Never use an incorrect or unsafe method of operation.

Starting

Position your Stump Grinder on flat, dry ground.

Put the brake on making sure the brake pin and wheel is engaged and locked.

Remove the towbar and towbar locking pin from the unit.

Make sure the fuel shut-off valve is in the "ON" position. Slide to the right.

Move the choke control lever to the "CHOKE" position (should only be needed if the

engine is cold). Left is on, Right is off.

Move the throttle control lever to the "MID" position.

Adjust your bow handle to the desired position.

Depress the safety shut off bail on the bow handle.

Raise the cutter teeth off the ground and start the engine. This is a direct drive unit and

the cutter wheel will rotate during starting.

10. Recoil Start: Turn the Ignition Switch to the "On" position. Grasp the recoil starter

handle and slowly pull until you feel resistance. Let the cord retract a little bit then pull

the cord rapidly to start the engine. One or two pulls usually starts the engine.

11. Electric Start: Turn and hold the Key in the start position until Engine starts then let

the Key return to run position.

12. Move the choke control lever (if used for cold engine) slowly back to the "RUN"

position when the engine is running well. All the way to the right.

13. Increase engine speed to FULL RABBIT RPM.

Part IV: Maintaining The Stump Grinder