3M 1700 Series Manuel de l'opérateur - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} 3M 1700 Series. 3M 1700 Series 8 pages. Overhead projector
Également pour 3M 1700 Series : Manuel de l'opérateur (9 pages)

Imprimer la page

INTENDED USE

Before operating the machine, please read the entire

manual thoroughly. The 3Mt Overhead Projector

1700 was designed, built and tested for use indoors,

using 3M brand lamps and nominal local voltages.

The use of other replacement lamps, outdoor

IMPORTANT SAFEGUARDS

When using your photographic equipment, basic

safety precautions should always be followed,

including the following:

Read and understand all instructions before

using. Pay particular attention to areas where

this symbol

is shown.

Close supervision is necessary when any

appliance is used by or near children. Do not

leave appliance unattended while in use.

Care must be taken as burns can occur from

touching hot parts.

Do not operate appliance with a damaged cord

or if the appliance has been dropped or

damaged — until it has been examined by a

qualified serviceman.

Position the cord so that it will not be tripped

over, pulled or contact hot surfaces.

If an extension cord is necessary, a cord with a

current rating at least equal to that of the

appliance should be used. Cords rated for less

amperage than the appliance may overheat.

Always unplug appliance from electrical outlet

before cleaning and servicing and when not in

use. Never yank cord to pull plug from outlet.

Grasp plug and pull to disconnect.

Let appliance cool completely before putting

away or when replacing lamp. Loop cord loosely

around appliance when storing.

To reduce the risk of electric shock, do not

immerse this appliance in water or other liquids.

Setup Instructions

1. Remove bolts (1) from projector body.

2. Align post holes (2) with mounting holes on

projector.

3. Insert bolts (3) through post holes and turn

finger tight.

4. Use wrench (4) to tighten bolts and secure post to

projector body.

n Note

Post bolt wrench (4) is taped to the projection post

3M 1700 Operator's Guide

operation or different voltages has not been tested,

and could damage the projector or peripheral

equipment and/or create a potentially unsafe

operating condition.

10. To reduce the risk of electric shock, do not

disassemble this appliance, but take it to a

qualified technician when service or repair work

is required. Incorrect reassembly can cause

electric shock when the appliance is used

subsequently.

11. The use of an accessory attachment not

recommended by the manufacturer may cause a

risk of fire, electric shock, or injury to persons.

12. Connect this appliance to a grounded outlet.

13. Disconnect this unit from its source of supply

before replacing the projection lamp.

14. This unit is equipped with optical lenses and

should not be exposed to direct sunlight.

15. Keep ventilation openings free of any

obstructions.

16. This unit is assembled with a special power

cable that, if damaged, must be replaced by the

same type of cable. This power cable can be

ordered from your local 3M Visual Systems

Division Dealer and must be installed by a

serviceman.

SAVE THESE

INSTRUCTIONS

The information contained in this manual will help you

operate and maintain your overhead projector.

n Important

Tighten bolts (1) with equal pressure.g

Page 1