Customatic STRATOSPHERE Manuel du propriétaire - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Customatic STRATOSPHERE. Customatic STRATOSPHERE 16 pages. Adjustable bed frame
Imprimer la page
Installation Guide
NOTE:
For safety reasons, lifting of the adjustable bed frame must always be performed by two
(2) people; and the unit should always be on a flat surface before opening.
Setting up your adjustable bed frame
1
Lift the bed frame unit out of the shipping carton carefully,
and put it on a flat floor.
2
Lower the head and foot frame pieces with their top side
facing downward. Make sure they are properly aligned at the
center.
3
Remove all accessory boxes and cut the orange ties from
inside the bed frame.
4
Take the center leg brackets, side rail brackets, M10 screws,
and the Allen key wrench from the accessory box.
5
Connect the head and foot sections of the frame using the
center leg bracket, lining it up with the pre-threaded holes
on the parallel bars.
6
Using the Allen key wrench, thread the M10 screws in a
clockwise direction into the bracket and through the holes
to keep it in place.
7
Repeat steps 5 and 6 to install the second center leg bracket
on the other end of the parallel bars.
8
Install the side rail brackets on the left and right side of the
bed frame.
9
Using the Allen key wrench, thread the M10 screws in a
clockwise direction into the bracket and through the pre-
threaded holes to keep it in place.
Attaching the bed legs
1
Take out the post bed legs from the accessory box.
2
Thread the bed legs into the pre-drilled holes on the bed
frame by turning them in a clockwise direction.
3
Tighten the legs securely to the frame.
NOTE:
Do not overtighten the bed legs.
6