AERMEC FCXI 40 U Manuel d'utilisation et d'installation - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'installation pour {nom_de_la_catégorie} AERMEC FCXI 40 U. AERMEC FCXI 40 U 17 pages. Fan coil with inverter

Imprimer la page

INSTALLATION

WARNING: check that the power sup-

ply is disconnected before carrying out

any procedures on the unit.

WARNING: the appliance must be fitted

according to the national regulations

on process plant engineering.

WARNING: electrical wirings, installation

of the fan coils and relevant accessories

should be performed by a technician

who has the necessary technical and

professional expertise to install, modify,

extend and maintain systems, and who

is able to check the systems for the pur-

poses of safety and correct operation.

INSTALLING THE UNIT

To install the unit, proceed as follows:

- Remove the air filter

- Remove the covering cabinet

- With wall-mounted units, keep a mini-

mum clearance of 80mm from the

floor. With floor-standing units on feet,

refer to the instructions supplied with

the accessory

- Use wall plugs (not supplied) for wall-

mounted installations

When using the support accessory (AMP

accessory), proceed as follows:

Assemble the 4 supports at the sides of

the device, inserting the upper tang in the

hole and fixing the lower part to the com-

ponent by means of the screws supplied.

Fix the flanges to the ceiling, using wall

plugs (not supplied); for the relative

positions between the flanges and the

component, refer to the size data

- Apply any accessories.

The VCF valve and the BC4 tray cannot

be installed at the same time on the

same fan coil.

M a k e t h e wa t e r c o n n e c t i o n s a s

described in the relative chapter.

Make the condensate discharge connec-

tion as described in the relative chapter.

WATER CONNECTIONS

- Make the water connections.

- In the event of disassembly and rein-

stallation, use new gaskets.

Refer to the size data for the position,

type and diameter of the water con-

nections.

You are advised to adequately insulate

water lines and/or fit the auxiliary

condensate drain tray (available as an

accessory), to prevent dripping during

WARNING: install a device, main

switch or plug which allows to com-

pletely cut off the power supply from

the unit.

Instructions which are essential for the

proper installation of the equipment are

given here.

The completion of all the operations

in accordance with the specific

requirements is however left to the

experience of the installation engineer.

The fan coil must be installed in such a

position that the air can be distributed

throughout the room and so that there

The fan coils that work in heat mode

only do not require condensate dis-

charge.

Make the electrical wiring as shown in

the relative chapter and in the wiring

diagrams.

Install and connect any accessories.

Complete the installation by reassem-

bling the casing and air filter.

Start up the fan coil and check all the

components and functions are operat-

ing correctly.

65 mm

the cooling function.

After installing, check the seal on the

connections.

are no obstacles (curtains or objects) to

the passage of the air from the suction

louvers.

The fan coil should be installed in such a

way as to facilitate routine (filter clean-

ing) and special maintenance opera-

tions, as well as access to the air drain

valve on the side of the unit frame

(connections side).

FCXI_AS

IFCXIUASLJ 1003 - 5383600_01

FCXI_U

AMP

FCXI_U