Customidea GeoPic II Manuel d'instruction - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Customidea GeoPic II. Customidea GeoPic II 20 pages. Geotagging device for nikon d200/d2hs/d2x/d2xs fuji s5 pro

Imprimer la page

Continuous mode (red)

Continuous mode (red)
This section explains how the GeoPic II behaves in its
continuous mode of operation. In this mode, the status
light will always be a red colour.
The continuous mode is the most basic mode of
operation. If GPS data is available, the GeoPic II will
continuously update the camera with the current location.
Data is sent regardless of the state of the camera:
Status light:
slow flashing
always on
The time that the GeoPic II takes to achieve a good lock
on the satellites will depend on a number of factors.
Typical lock times are given in the technical details at
the end of this manual.
Once the GeoPic II is locked, any pictures taken with
your camera will be geotagged with the current GPS
location.
You will notice that when the GeoPic II is in the
continuous mode and locked, the camera will not leave
its metering state (i.e. where metering information is
shown on the camera LCD). Since the camera uses far
more power in metering state than standby state, the
battery life in continuous mode will be significantly
reduced. This is not the case in the low power mode
which is discussed in the next section.
Nikon D200, D2HS, D2X and D2XS and Fuji S5 Pro are registered
Function button:
No function
(Mode change
with half press)
No function
(Mode change
with half press)
trademarks or a trademark of their respective companies.
7
Description
The GeoPic II does not have a
sufficient lock on the satellites, and
is not sending any GPS data to the
camera. The camera's GPS icon will
not be visible in its display.
The GeoPic II has locked to three or
more satellites and is continuously
updating the camera with the GPS
location. The camera's GPS icon
will be visible in its display.