Artistry In Motion Big Shots Manuel d'utilisation et d'entretien - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Artistry In Motion Big Shots. Artistry In Motion Big Shots 12 pages. Wireless transmitter and receiver
Également pour Artistry In Motion Big Shots : Instructions de chargement et de tir (2 pages)

Imprimer la page

3.1.2 ARM: Connect the Wireless Big Shots® Receiver connector to the Big

3.13

3.14

3.1.5 STORE: When finished turn off the receiver "ON/OFF" switch to the

Artistry In Motion, Inc.

Tel: 818.994.7388

Ver 08/20

receiver so that their separation does not exceed ¾ of this maximum

range. Verify that the input voltage is adequate by observing the flashing

green "BATTERY" and "ARMED" lights on the receiver and transmitter,

respectively. Operation of these indicators is as described in section 1.3

above. Turn the transmitter lock switch back to "Safe" position, and turn

off the receiver.

Shots® solenoid valve plug as described in section 1.4 above. With the

"ARM" switch turned off, turn on the receiver power switch. The red

indicator should remain off. Check that the green "BATTERY" indicator is

only flashing in bursts of one, two or three to indicate input voltage

If this indicator exhibits continuous or erratic behavior, there is a

signal being received, which will cause firing when the "ARM"

switch is turned on.

attempting to use the system.

CHECK: Verify that the Big Shots® accumulator tank has not been

pressurized and that the barrels have not been filled with confetti or

streamers. Verify that the "Battery" indicator does not show reception of

firing signals. Now, move the "ARM/SAFE" toggle from "SAFE" to "ARM".

FIRE: Turn the transmitter toggle switch to its "Armed" position, and

press the "FIRE CH A" button to actuate the receiver output. The "FIRE"

and the "BATTERY" lights on the receiver should both light up red. You

should hear the solenoid valve in the Big Shots® Cannon click as it

opens and closes. If the "Fire" and "Battery" lights flash red, but you do

not hear the solenoid click, you should verify that the solenoid plug is

completely seated in the receiver receptacle, and that the solenoid is fully

seated on the valve stem. Repeat this test until you are certain of the

continuity of your system. When you are satisfied with the continuity of

your system, return the transmitter and the receiver to the "SAFE"

positions. You are now ready to fill the Big Shots® accumulator tank and

load the confetti or streamers in the barrels.

Please note: The "Fire" buttons must be depressed for at least 100

milliseconds to produce a transmitter output. The transmitter should be

held with the antenna in the same orientation as the Receiver Antenna,

away from the body and other conductive objects to achieve maximum

range and communication reliability. Generally, the higher the transmitter

is held, the greater the range.

"OFF" position and "ARM/SAFE" switch to the "SAFE" position. You also

should turn the transmitter lock switch back to its "SAFE" position. These

actions will stop further drain of the power sources. If the receiver is to be

stored for a prolonged period, charge its batteries as described in section

1.5 above.

19411 Londelius Street, Northridge, CA 91324

Fax: 818.994.7688

Determine the source of the interference before

Website:www.artistryinmotion.com

status.

Page 10