Altwork Station Manuel de démarrage rapide - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Altwork Station. Altwork Station 11 pages.

Imprimer la page
The new way to work.

Keypad Control Panel

2
The Keypad is the control center of the Altwork Station. This controls
the Station's motion through the Sitting-Standing-Focus (semi-recline
and full recline) to support your favorite body postures.
MEMORY BUTTONS 1-4 + Standing
There are five (5) user programmable
Memory Buttons.
These allow you to find a comfortable
position and set into "memory" with a
programmable button. After setting the
position it is a simple push and hold of the
Memory Button to return to that position in
the future.
To set the Memory Buttons
1. Adjust the Station to a comfortable
position
2. Press the Set button once until the
light turns on
3. Press the Number button you want for
that position – the Set button light will
blink to confirm your position, and then
Set light will remain solid for approx. 5
seconds.
NOTE: You can set 4 positions for 1 user –
or, 1 position for 4 users!
If your desired position is standing, push the
Standing Memory Button
FACTORY PRE-SET BUTTON
The Home setting is the best position to enter
and exit the Station.
NOTE: the Keypad buttons have built-in safety features that require the
user to push and hold the button down to activate motion. The motion
will immediately stop when a button is released.
Green light shows the Station is powered on
Motion - White
• Lit while the Station is moving
• Blinking when the Station is at full range of possible
motion or when the desired memory location has been
reached
Desk Open - White
• When LED is on, only the Desk can be raised or lowered
To gain full Station motion, the Desk must be rotated
back against the rear stop
Reset Required - Amber Yellow
• If lit, an unexpected fault has occurred and the Station
software needs to be reset. See procedures below
Safety - Red
• When LED is on, the Station will not move and the user
must push the Seat-back backwards against its stop
Seat-back: used to adjust the Seat-back angle
Desktop Vertical: used to raise or lower the Desktop +
Monitor in standing postion.
Leg Rest Extensions: to partially or fully extend the
Leg Rest (in some instances you may not want wish to
extend the last panel—if you are wearing heavy shoes,
high heels, etc.)
Leg Rest Angle: allow you to raise or lower the angle of
the entire Leg Rest as a single unit
STANDING BUTTON
The Standing setting is a quick way to get the Desktop
and Monitor into a comfortable height to work standing
up. You can adjust and then set to your preference for
future use (follow Pre-set directions)
5