Alu Rehab Netti Mobile Manuel d'entretien - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Alu Rehab Netti Mobile. Alu Rehab Netti Mobile 10 pages.

NETTI MOBILE MAJOR SERVICE LIST

CHECK

CHECK BOX

You may notice that even if a chair does not veer when driving forward it

does veer when driven backwards. This is due to the commutation angle of

the motors being optimised for driving forward. This is normal for this class

of motor. If veer in reverse is a matter of great concern it will be necessary

to adjust the veer parameter to allow some veer forward and backwards or

to change the control system to a gyro module. This option is available on

DX2 chairs at additional cost.

Tyre pressure –(pneumatic only) should be 3.5 bar

Tyre condition - check for cracks or abnormal wear.

Cables - check that the insulation on the cables is intact and that there are

no signs of heat damage. Check that any cable that might move during

normal operation of the chair remains flexible. If there are any signs of

work hardening, (such as a length of a cable that has become bent stiff

and cannot be straightened the cable has been checked more closely and

replaced if necessary.

Tie down any loose cables, free any trapped cables and check they are

not being constrained within the relevant minimum bending radii. Note:

for Dynamic bus cables: 50mm for continuous flexing and 30mm for

occasional flexing. Check that any bus cables attached to a controller

mounted on a swing-away arm do not be become bent through a radius of

less than 50mm at any point during the movement of the swing-away arm.

To achieve this you may need to modify or replace the arm rest. In case of

difficulty, contact Alu Rehab customer services for advice.

Electronics control system modules: check they are dry, check all

connectors are intact and inserted properly and that they are not loose.

Check all chair functions

User controllers, (such as joystick remotes): clean then check the case for

damage and cracking. Make sure all connectors are secure and are fixed

firmly in the casing. If there is any sign of movement the controller should

be considered to be unsafe. If there is a joystick check the gaiter is not

damaged as this will allow liquid to contact the electronic pcbs. Check that

the icons on any manual switches are legible. If any of these checks are

failed, exchange the user remote control for a new one.

Meas

Language: English Model: Netti Mobile Version: December 2013 (3)