Alula RE657WF Manuel - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Alula RE657WF. Alula RE657WF 12 pages. Flat mount touchpad
Également pour Alula RE657WF : Manuel (12 pages)

Imprimer la page

Installation Overview for BAT-Connect

1. Choose a mounting location.

2. Identify your network and verify signal strength before mounting it permanently.

1. Ensure the system is powered.

2. Power the Touchpad by applying AC power.

Note: The Touchpad cannot run off panel bus. Existing wiring needs to be moved to the

provided power adapter. For additional details, please refer to Touchpad Mounting section.

3. Select the "Connect" option to see the available networks. If the "Connect" option is

not available, press "Setup" then "Factory Default". The Touchpad should be directly

connected to the BAT-Connect access point. The Touchpad can access the internet directly

through the BAT-Connect.

Note: Internet access allows camera control and the ability to modify users.

4. Once a network is determined, verify the signal strength. If the signal strength displayed is

less than 35, relocate the Touchpad or BAT-Connect.

Note: in order for the Touchpad to access the internet through the BAT-Connect access

point, the BAT-Connect must be connected via ethernet or Wi-Fi.

BAT - CONNECT - V

BAT - Connect - V

BAT - Connect, M1, VZ

MAC:123456005B14

Date: 19295

Patent Pending

3. Mount the Touchpad. Refer to section "Touchpad Mounting" for mounting instructions.

4. Enroll the Touchpad by pressing the enroll button on the BAT-Connect for 2-3 seconds. Select

your network, then select next. Enter the CRC of the BAT-Connect, which can be found on

the inside cover of the

and authentication. Upon success it will show the DISARMED screen. If the wrong device was

selected, press the "Restart"button in the side menu.

Troubleshooting Steps if Enrollment Fails:

• Confirm the system is disarmed and in wireless enrollment mode. The DeviceLink LED

on the BAT-Connect will flash when in enrollment mode.

• Check whether the panel is already full. The limit is four Touchpads. To confirm

number of Touchpads connected, log into your account.

• Tap the "Restart" button to try again.

BAT-Connect.

The Touchpad will progress through stages of discovery