Alula RE667 Manuel - Page 12
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Alula RE667. Alula RE667 13 pages. Slimline touchpad
Également pour Alula RE667 : Manuel (12 pages), Manuel (12 pages)
Imprimer la page
Specifications
Physical Specifications
Wall Dimensions
Table Top Footprint
Weight
Pilot Hole for Screw into Wood
Pilot Hole for Wall Anchor
Mounting Fasteners
Environmental Specifications
Operating Temperature
Maximum Humidity
Device Specifications
Battery Life
Power Transformer
Input
Output
Part Number
Terminal Block Wire Gauge
Wireless Range
Screen Resolution
Screen Size
Accessories
Wi-Fi DeviceLink
Certifications
RE667B, RE667W
IC NOTICE
This device complies with Industry Canada license-exempt
RSS standard(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including
interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux cnr d'Industrie
Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) L'appareil ne doit pas produire de brouillage, et
(2) L'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
TRADEMARKS
Alula and Connect+ are trademarks owned by Alula
Holdings, LLC. Android is a trademark of Google LLC.
Z-Wave is a registered trademark of Silicon Labs. Wi-Fi is a
trademark of The Wi-Fi Alliance.
FCC Statement
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
4.27in[10.84cm] x 7.42in[18.85cm] x 1.60[4.06cm] Deep
4.58in[11.64cm] x 7.42in[18.85cm] x 6.63[16.84cm] High
1.29lbs[585g]
Ø 1/8in [3mm]
Ø 3/16in [4.7mm]
#6 screws & 4 wall anchors (included)
32°F to 120°F (0°C to 49°C)
85% non-condensing relative humidity
4 hours
100-240vac 50/60hZ 0.5A
12VDC, 1A
RE012-6
16-24 AWG
~300 feet in open air
1024 x 600 pixels
7 inches diagonally
RE926RX (only needed for Connect+)
FCC, IC, RCM
Specifications subject to change without notice.
Caution: Any changes or modifications to this device not explicitly
approved by manufacturer could void your authority to operate this
equipment.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for
help.
Specific Absorption Rate (SAR) information:
This Communicator meets the government's requirements for
exposure to radio waves. The guidelines are based on standards
that were developed by independent scientific organizations
through periodic and thorough evaluation of scientific studies.
The standards include a substantial safety margin designed to