Alula RE667-Pro Manuel - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Alula RE667-Pro. Alula RE667-Pro 12 pages. Slimline touchpad

Imprimer la page

• Panel (must enter code to access)

• Global Chime - enables or disables panel sensor chime mode

• Quick Arm - arm the panel without entering your access code. Access code is still

required to disarm.

• Manage Access - manage device users directly from the touchpad (only the account

owner can modify users, internet access is required)

• Edit Installer User - configure the system's installer access code and password. The

installer password can be used to connect to a Connect+ panel via the Connect+

Installer app.

• Dealer Code - configure the dealer code used by BAT-Connect to program the system

Note: Only available for Napco panels.

• Push User Pins to Locks - if Z-Wave locks are present, this will erase all existing access

codes from all door locks, and push all user pin codes to those locks. Pins will be

cropped to 4 digits before being programmed into the locks.

• UL Compliant Mode - when enabled the Connect+ and BAT-Connect will adhere to UL

standards. Dealer or Installer authority is required to configure this option.

• Keypads - lists the panel's keypads

• Rename keypads by selecting an item on the list and holding it for 2 seconds

• Reset Sensor - when there are sensors that latch open, such as a smoke detectors, they

can be reset here.

• Communication Test mode

• The Touchpad will begin testing communications and display "TESTING"

• After one minute, the Touchpad will show the result of the test which will be either

"GOOD," "FAIR," OR "POOR"

• If you get a "POOR" test result, try the test again from another location

• The table below lists the thresholds used to determine the outcome of the test

• If any statistic falls in the poor range, the test outcome is "POOR"

• If there are no poor statistics and any statistic is in the fair range, the outcome of

• If all statistics are in the good range, the outcome of the test is "GOOD"

Statistic

Wi-Fi Signal

Strength

Communication

Success Rate

Response Time

Average

• Check for updates - this will tell the panel to check for any system updates

• Z-Wave

• Join/Leave Another Z-Wave Network - the panel can be placed into Z-Wave

inclusion or exclusion mode to allow it to join/ leave existing Z-Wave networks.

• Soft Reset - a soft reset will reset the Z-Wave controller software. All Z-Wave devices

will remain enrolled.

• Hard Reset - this action will cause your Connect+ Z-Wave module to be restored

back to the default state. Warning: Performing this action results in all Z-Wave

devices being removed from this Z-Wave controller. To add them back, you will first

need to exclude them, and then include them again.

**PLEASE SEE Z-WAVE USER GUIDE FOR ADDITIONAL INFORMATION**

• About - lists information about the panel's installed hardware and software

the test is "FAIR"

Unit

GOOD

Over 39

Over 89

Under 200

FAIR

35 to 39

85 to 89

200 to 250

POOR

Under 35

Under 85

Over 250